What is test prop

A handy tool for this project is the drying rack for the eyes. I made mine from two 4″ pieces of wire coat hanger and a small flat piece of scrap wood. Just drill two appropriately sized holes in the wood, cut two straight pieces of wire coat hanger and insert them in the holes. You will need to make sure that the drill bit is the same diameter as the coat hanger to ensure a tight fit. For the record, I used a thin wire hanger and a 47 gauge (″) drill bit. This will allow you work around the eyes completely without getting your fingers in the paint, and to set them aside to dry on your work surface. 

Looking at box stock props, the Trophy is a good but the Pro Max should offer better overall performance and durability. The 8″ jack plate might offer a little better performance when you marry with the right prop. I think the Pro Max, with its tremendous cup wrapped around the blade tips, will give you what you’re looking for with the set back. The Trophy is ″ in diameter. The Pro Max is ″. The props share the same hub size. The Pro Max doesn’t have vent holes nor does it need them. There’s enough exhaust venting over the small hub. The plastic blow out ring fitted over the front of the Trophy would hurt the Pro Max’s planing performance. I think the Pro Max would be a fun prop for your set up.

What is test prop

what is test prop

Media:

what is test propwhat is test propwhat is test propwhat is test propwhat is test prop

http://buy-steroids.org