The height increase depends on set-up and prop diameter. The Bravo I XS is a large diameter propeller. Typically, those running it raise the engine 1/2″ higher than the standard transom height. I’ve seen some run their Bravo I XS engines as high as 1″ above the standard height. It all depends on the application and what you want to get out of it. Hole shot – mid-range punch or top-end speed. A hydraulic transom plate enables the operator to experience the full capabilities of the Bravo I XS. Bottom line, you have to try and figure out what works best for your application.
Add a subdirectory to the build. The source_dir specifies the directory in which the source and code files are located. If it is a relative path it will be evaluated with respect to the current directory (the typical usage), but it may also be an absolute path. The binary_dir specifies the directory in which to place the output files. If it is a relative path it will be evaluated with respect to the current output directory, but it may also be an absolute path. If binary_dir is not specified, the value of source_dir, before expanding any relative path, will be used (the typical usage). The file in the specified source directory will be processed immediately by CMake before processing in the current input file continues beyond this command.
If there is only one group, then the null tested is that the underlying probability of success is p , or .5 if p is not given. The alternative is that the probability of success if less than, not equal to, or greater than p or , respectively, as specified by alternative . A confidence interval for the underlying proportion with confidence level as specified by and clipped to [0,1] is returned. Continuity correction is used only if it does not exceed the difference between sample and null proportions in absolute value. The confidence interval is computed by inverting the score test.